|
[Sponsors] |
September 14, 2005, 16:10 |
radial turbine data export question
|
#1 |
Guest
Posts: n/a
|
Hi
Im hoping someone can give me some advice on exporting static pressure data from a radial turbine simulation. At the minute i have ran a few steady state (frozen rotor) simulations of complete stages, and i am tring to extract static pressure information around rotor inlet. I am currently creating circumferential plots of static pressure at rotor inlet (which initially give a very spiky profile) and attempting to average the data over each blade. Thus far i am having trouble getting the results to line up with experimantal data using this method. Is there any preferable method of determining the static pressure distribution at rotor inlet from steady state models? Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
CFD analysis on wind turbine rotor | Ken (Wind Turbine CFD Super Rookie) | Main CFD Forum | 45 | February 9, 2016 15:07 |
Direction of Rotation of Radial Turbine | ghoshi1983 | CFX | 8 | June 19, 2012 11:16 |
Wind Turbine Experimental Data | naimishharpal | Main CFD Forum | 7 | May 1, 2011 23:48 |
radial turbine blade simulation with dynamic mesh 6dof(fluent) | mamyjooooon | FLUENT | 0 | April 7, 2011 15:28 |
about export data file in cfx-post | lingo | CFX | 0 | October 30, 2004 09:48 |