 |
 |
 |
|
|
|
[Sponsors] | ||||
September 6, 2005, 10:34
|
grids between tip clearance
|
#1 |
|
Guest
Posts: n/a
|
hi,everyone.
my model is a axial pump,and the tip clearance is very short to the whole radius. and i met a problem for grids. when i make ogrids for blade,i don't know where to put the ogrids vertices between the shroud and blade tip. and some grids are always wrong with small angel ,such as 0-9 degree. how to avoid this situation? thank you very much! |
|
|
||
|
September 7, 2005, 06:19
|
Re: grids between tip clearance
|
#2 |
|
Guest
Posts: n/a
|
I dint get your question saying the axial pump having a shroud? In axial flow pumps the impeller blades are with the hub only. What is the clearence between impeller and casing.?
|
|
|
|
||
|
September 7, 2005, 09:11
|
Re: grids between tip clearance
|
#3 |
|
Guest
Posts: n/a
|
ah~ the pump was cased, and tip clearance is very small.could you tell me how to set the grids? thank you very much!
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Turbine blade with filleting and tip clearance | Pursuor | ANSYS Meshing & Geometry | 4 | July 7, 2010 14:56 |
| Meshing in tip clearance. | me | Siemens | 0 | August 25, 2008 04:20 |
| grids in tip clearance | iceraining | Main CFD Forum | 2 | September 12, 2005 01:50 |
| Tip Clearance | Liam | CFX | 3 | September 7, 2005 06:30 |
| Tip Clearance | Drona | CFX | 0 | October 17, 2002 06:25 |
Linear Mode
