A way of creating blocks in ICEM for seal region -- CFD Online Discussion Forums

August 22, 2005, 12:21	A way of creating blocks in ICEM for seal region	#1
Mustafa T Guest Posts: n/a	Experts, I'm stuggling to find a good way of generating a good mesh for the knife edge seal region with honey coomb present. I'm using ICEM blocking technique. But I notice, I'm not able to get much control over mesh density and my mesh is becoming large enough. I attach a picture showing you the case. Please let me is there a way by which I can have fine mesh in the tooth gap region and coarse mesh in the pocket region. Honey coomb mesh got finner mesh at the top

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
dsmcInitialise - dsmcFoam	archymedes	OpenFOAM Pre-Processing	94	July 15, 2016 17:14
[Commercial meshers] Using starToFoam	clo	OpenFOAM Meshing & Mesh Conversion	33	September 26, 2012 05:04
[Other] StarToFoam error	Kart	OpenFOAM Meshing & Mesh Conversion	1	February 4, 2010 05:38
A way of creating blocks in ICEM for seal region	Mustafa T	CFX	1	August 23, 2005 04:37
[Gmsh] Import gmsh msh to Foam	adorean	OpenFOAM Meshing & Mesh Conversion	24	April 27, 2005 09:19

All times are GMT -4. The time now is 22:56.