|
[Sponsors] |
July 4, 2005, 06:18 |
Massflow
|
#1 |
Guest
Posts: n/a
|
Hi,
Maybe this subject has been discussed before, but I wonder what is the right way to calculate the mass flow in CFX-post? 2 choices: "massflow()@plane1" and "AreaAve(massflow)@plane1" And the results are completely differents, so I'm a litle bit confused. Thanks for your help. Juan |
|
July 4, 2005, 11:02 |
Re: Massflow
|
#2 |
Guest
Posts: n/a
|
massFlow()@Plane1 is the right choice!
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
MassFlow Function? Absolute MassFlow? Failure in Caclulation | eRzBeNgEl | CFX | 0 | May 5, 2011 10:46 |
a question about Massflow Calculation | xck1986 | OpenFOAM | 1 | January 29, 2011 13:47 |
calculate MASSFLOW for a component | MAldaz | CFX | 1 | November 7, 2007 12:41 |
massflow outlet in flunet. | shrinath | FLUENT | 0 | September 3, 2007 10:40 |
re: Massflow reset in CFX 10 | Wooster | CFX | 5 | March 16, 2007 21:08 |