 |
 |
 |
|
|
|
[Sponsors] | ||||
February 1, 2005, 00:43
|
What does part ORFN in ICEM 5.1 mean?
|
#1 |
|
Guest
Posts: n/a
|
Hi all,
When I create the body using material point, a new part ORFN is generated at the same time. If I delete this part, the body that I created will disappear as well. Anyone know why & what ORFN is? Thanks for help, TB |
|
|
||
|
February 1, 2005, 17:00
|
Re: What does part ORFN in ICEM 5.1 mean?
|
#2 |
|
Guest
Posts: n/a
|
Hi,
It is discussed in the documentation. It represents the region not contained inside the geometry. Glenn Horrocks |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Problem while improting Solidworks Part file or Acis File into ICEM CFD | venki1130 | ANSYS Meshing & Geometry | 0 | October 13, 2011 14:04 |
| Importing Solidworks part into ICEM CFD | MetalSupremacist | FLUENT | 0 | October 8, 2010 18:46 |
| icem hexa - load different blockings for each part of geometry??? | Catthan | ANSYS Meshing & Geometry | 2 | May 28, 2010 12:27 |
| ICEM: ORFN elements | DAK565656 | CFX | 3 | December 20, 2005 06:27 |
| ICEM CFD 5.1 Hex-Tet mesh merging failure | bogesz | CFX | 1 | January 29, 2005 07:46 |
Linear Mode
