 |
 |
 |
|
|
|
[Sponsors] | ||||
January 11, 2005, 07:22
|
CFX5.6 (Build) Parallel Meshing
|
#1 |
|
Guest
Posts: n/a
|
Did anyone ever use the parallel meshing that was supposedly available in the version of Build that came with CFX5.6. We've found a paper saying that it was available but see no evidence of it in the software.
|
|
|
||
|
January 11, 2005, 13:25
|
Re: CFX5.6 (Build) Parallel Meshing
|
#2 |
|
Guest
Posts: n/a
|
I never used it, but I know it was available. You would need a special license with build to use it.
|
|
|
|
||
|
January 12, 2005, 13:39
|
Re: CFX5.6 (Build) Parallel Meshing
|
#3 |
|
Guest
Posts: n/a
|
All you need is a CFX-5 Solver Parallel license.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Parallel meshing with OP 2.0.0 | Aurelien Thinat | OpenFOAM Meshing & Mesh Conversion | 34 | March 27, 2012 19:55 |
| Parallel Meshing in ANSYS 13 | makkks | ANSYS Meshing & Geometry | 1 | September 5, 2011 13:34 |
| Parallel meshing + simulating. need Help | nicolarre | OpenFOAM | 2 | April 11, 2011 12:04 |
| Parallel meshing using XP64 with PVM in CFX Mesh | Huw | ANSYS Meshing & Geometry | 4 | July 12, 2010 11:24 |
| Meshing support parallel multiple computers! | Kevin | Siemens | 1 | July 26, 2007 20:27 |
Linear Mode
