|
[Sponsors] |
October 22, 2004, 07:00 |
Re: ICEM 5.0
|
#1 |
Guest
Posts: n/a
|
Hi everyone! I draw a concentric cylinder using ICEM 5.0, i creat different parts for the cylinder and assign boundary conditions for them. But the .geo file only shows the b.c for inlet and outlet, but not other parts inside the cylinder. Do anyone know how i can assign boundary conditions for the parts inside the cylinder?
Thanks Joan |
|
October 22, 2004, 17:05 |
Re: ICEM 5.0
|
#2 |
Guest
Posts: n/a
|
Hi
I assume you're using Hexa. If so, it might be something to do with you not correctly associating faces to surface parts. Regards James |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ICEM CFD 5.0 - 2D to 3D Mesh Extrude | James Date | CFX | 7 | October 22, 2013 03:46 |
ICEM CFD 5.0 (Hexa) - Internal Wall/Thin Surface | James Date | CFX | 3 | August 10, 2012 04:47 |
Problem with ICEM CFD 5.0 | sac | CFX | 4 | October 15, 2004 11:28 |
ICEM 5.0 to IGES | Christian | CFX | 0 | September 29, 2004 11:44 |
Free seminar: ICEM CFD version 5.0 | Gavin Butcher | CFX | 0 | June 17, 2004 10:49 |