|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hello Everyone, 1 How can I do if I want CFX-5.7 to export data for Tecplot? Just for an example, to export temperature on a surface in a Tecplot format?
2 How can I do if I want to get a monitor for the average temperature of a surface? Does the "monitor points" only deal with a single point? Thanks. |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
To monitor average temperature on surface just write expression (areaAve(T)@your location). Then add monitor point, but switch from point to expression so you get monitoring of average temperature.
|
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
Thank you very much deLuther!
|
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
monitoring boundary and engineering data | Lawrence | STAR-CD | 4 | April 6, 2010 14:58 |
saving monitoring data | mange | FLUENT | 2 | March 3, 2009 05:54 |
How to update polyPatchbs localPoints | liu | OpenFOAM Running, Solving & CFD | 6 | December 30, 2005 17:27 |
Monitoring Reference Data for Air | furkan | Siemens | 2 | December 16, 2005 06:58 |
Saving data from monitoring points | Astrid | CFX | 3 | April 10, 2002 04:55 |