Writing mass fraction data file

September 16, 2004, 02:49

I am simulating diffusion of chlorine dioxide (modeled as species) as a part of my project. If someone can guide me how to make data file to write out chlorine dioxide concentration at every cell during steady state flow, it would be of great help.

I would also like to write the X, Y, & Z values (which are distances and therefore it should be in units of meters) at the corresponding concentration value. Thus the output file created would look like as shown below; four column with particular values.

X Y Z Conc.

Please help Sankalp

September 17, 2004, 11:54

Are you useing CFX-5?

Jeff

September 16, 2004, 02:49	Writing mass fraction data file	#1
Sankalp Guest Posts: n/a	I am simulating diffusion of chlorine dioxide (modeled as species) as a part of my project. If someone can guide me how to make data file to write out chlorine dioxide concentration at every cell during steady state flow, it would be of great help. I would also like to write the X, Y, & Z values (which are distances and therefore it should be in units of meters) at the corresponding concentration value. Thus the output file created would look like as shown below; four column with particular values. X Y Z Conc. Please help Sankalp

September 17, 2004, 11:54	Re: Writing mass fraction data file	#2
Jeff Guest Posts: n/a	Are you useing CFX-5? Jeff

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[swak4Foam] swak4foam building problem	GGerber	OpenFOAM Community Contributions	54	April 24, 2015 17:02
pisoFoam compiling error with OF 1.7.1 on MAC OSX	Greg Givogue	OpenFOAM Programming & Development	3	March 4, 2011 18:18
Installation of OpenFOAM-1.6 on Ubuntu 9.10	marval	OpenFOAM Installation	2	March 17, 2010 09:33
Problem installing on Ubuntu 9.10 -> 'Cannot open : No such file or directory'	mfiandor	OpenFOAM Installation	2	January 25, 2010 10:50
Regarding FoamX running Kindly help out	hariya03	OpenFOAM Pre-Processing	0	April 18, 2008 05:26