negative volume in turbogrid

September 16, 2004, 00:08

Hi: when i creat grid in turbogrid,there are negative volumes .Maybe moving control points can solve it.However,I don't know how to move it.The manual never tell me what to do.

Could you give me any suggestion ?

Regards

lingo

October 8, 2004, 11:56

when it happens, there should be an information given by the turbogrid, you can try to use the method suggested by it to solve it: template-->flip topology. use this to change from left-handed system to right-handed system.

if it does not work, please give me an email.

September 16, 2004, 00:08	negative volume in turbogrid	#1
lingo Guest Posts: n/a	Hi: when i creat grid in turbogrid,there are negative volumes .Maybe moving control points can solve it.However,I don't know how to move it.The manual never tell me what to do. Could you give me any suggestion ? Regards lingo

October 8, 2004, 11:56	Re: negative volume in turbogrid	#2
feng Guest Posts: n/a	when it happens, there should be an information given by the turbogrid, you can try to use the method suggested by it to solve it: template-->flip topology. use this to change from left-handed system to right-handed system. if it does not work, please give me an email.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 07:09
channelFoam for a 3D pipe	AlmostSurelyRob	OpenFOAM	3	June 24, 2011 14:06
[blockMesh] BlockMesh FOAM warning	gaottino	OpenFOAM Meshing & Mesh Conversion	7	July 19, 2010 15:11
On the damBreak4phaseFine cases	paean	OpenFOAM Running, Solving & CFD	0	November 14, 2008 22:14
[blockMesh] Axisymmetrical mesh	Rasmus Gjesing (Gjesing)	OpenFOAM Meshing & Mesh Conversion	10	April 2, 2007 15:00