Cfx

shezi266 · July 2, 2018, 16:26

any one can help me on turbocharger simulation

ghorrocks · July 2, 2018, 20:01

Yes, we can help.

shezi266 · July 9, 2018, 06:43

Hi firstly thanks for your attention,
I find it difficult to start with cfx-pre (boundary conditions in particular) setup as i am new to cfd....my model comprises of two components(turbine and compressor) which makes it even harder to understand....need help in this regard; a tutorial might work.

-Maxim- · July 11, 2018, 05:59

Have done the tutorials from ANSYS? There are also a lot of youtube videos for beginners that you could do.
In this forum we can only help with specific questions.

shezi266 · August 5, 2018, 10:43

hello ghorrocks sir,
sir iam using solid works for simulation of turbocharger compressor. so i have problem in manual mesh settings , can you please tell me on what criteria manual mesh settings can be set
thanks

ghorrocks · August 5, 2018, 20:06

I will quote Maxim:

Quote:

Have done the tutorials from ANSYS? There are also a lot of youtube videos for beginners that you could do.
In this forum we can only help with specific questions.

July 2, 2018, 16:26	Cfx	#1
shezi266 New Member Shahzad Join Date: Jul 2018 Posts: 22 Rep Power: 8	any one can help me on turbocharger simulation

July 2, 2018, 20:01		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,871 Rep Power: 144	Yes, we can help. __________________ Note: I do not answer CFD questions by PM. CFD questions should be posted on the forum.

July 9, 2018, 06:43	Getting started with CFX-Pre	#3
shezi266 New Member Shahzad Join Date: Jul 2018 Posts: 22 Rep Power: 8	Hi firstly thanks for your attention, I find it difficult to start with cfx-pre (boundary conditions in particular) setup as i am new to cfd....my model comprises of two components(turbine and compressor) which makes it even harder to understand....need help in this regard; a tutorial might work.

August 5, 2018, 10:43	mesh settings	#5
shezi266 New Member Shahzad Join Date: Jul 2018 Posts: 22 Rep Power: 8	hello ghorrocks sir, sir iam using solid works for simulation of turbocharger compressor. so i have problem in manual mesh settings , can you please tell me on what criteria manual mesh settings can be set thanks

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
CFX Treatment of Laminar and Turbulent Flows	Jade M	CFX	18	September 15, 2022 08:08
High Resolution (CFX) vs 2nd Order Upwind (Fluent)	gravis	ANSYS	3	March 24, 2011 03:43
CFX pressure in Simulations problem	nasdak	CFX	1	April 14, 2010 14:22
PhD using CFX	Rui	CFX	9	May 28, 2007 06:59
FSI using CFX and ANSYS	Bi Chang	CFX	2	May 10, 2005 05:47

July 11, 2018, 05:59		#4
-Maxim- Senior Member Maxim Join Date: Aug 2015 Location: Germany Posts: 413 Rep Power: 13	Have done the tutorials from ANSYS? There are also a lot of youtube videos for beginners that you could do. In this forum we can only help with specific questions.