how to create animation

March 17, 2004, 23:58

I need to animate model analysis in CFX, and I don't know how to use the animation icons.Its require keyframe to create the animation but I don't know how to create it.

March 19, 2004, 09:14

go through tutorial 1 in the help manual.. that should explain a few things to you.. If you are doing an animation for transient cases, load the results of the first timestep and create the necessary plots.. capture this as the first frame.. load the lat time step and capture this as the next frame.. By default the no of frames per sec in an mpeg file is about 24 but the animation manager puts only 24 frames by default.. You can increase this no in the animation manager to get a bigger movie

March 17, 2004, 23:58	how to create animation	#1
sya81 Guest Posts: n/a	I need to animate model analysis in CFX, and I don't know how to use the animation icons.Its require keyframe to create the animation but I don't know how to create it.

March 19, 2004, 09:14	Re: how to create animation	#2
test Guest Posts: n/a	go through tutorial 1 in the help manual.. that should explain a few things to you.. If you are doing an animation for transient cases, load the results of the first timestep and create the necessary plots.. capture this as the first frame.. load the lat time step and capture this as the next frame.. By default the no of frames per sec in an mpeg file is about 24 but the animation manager puts only 24 frames by default.. You can increase this no in the animation manager to get a bigger movie

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 07:09
[blockMesh] Include list of points	Hikachu	OpenFOAM Meshing & Mesh Conversion	0	June 20, 2011 10:03
Actuator disk model	audrich	FLUENT	0	September 21, 2009 08:06
Where's the singularity/mesh flaw?	audrich	FLUENT	3	August 4, 2009 02:07
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 12:55