Particle simulation in CFX 5.6

March 16, 2004, 09:07

Hi

I have a problem with the particle simulation in CFX 5.6. I inject particle in 5 different mass range into a pipe system.

But after 1/4 of the pipe lenght the particle track stops.

Why is this happing ?

Any hints.

Regards

Jens

March 18, 2004, 07:57

Jens, could be the simultion time of the particls has run out ? There is a time limit in the setup and if the particls are still in the domain when this time limit runs out then they just stop. Check through the GUI's and on particle setup and you will find this, just make it larger and it should solve your problem Bob

March 16, 2004, 09:07	Particle simulation in CFX 5.6	#1
Jens Guest Posts: n/a	Hi I have a problem with the particle simulation in CFX 5.6. I inject particle in 5 different mass range into a pipe system. But after 1/4 of the pipe lenght the particle track stops. Why is this happing ? Any hints. Regards Jens

March 18, 2004, 07:57	Re: Particle simulation in CFX 5.6	#2
Bob Guest Posts: n/a	Jens, could be the simultion time of the particls has run out ? There is a time limit in the setup and if the particls are still in the domain when this time limit runs out then they just stop. Check through the GUI's and on particle setup and you will find this, just make it larger and it should solve your problem Bob

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
CFX steady simulation	gharek	CFX	1	April 7, 2010 19:41
cfx particle convergence problem	bharath	CFX	0	November 11, 2009 09:34
CFX particle tracking	Mehmet SORGUN	CFX	0	February 4, 2009 14:24
CFX diffuser simulation	Ianto	CFX	8	November 20, 2008 03:45
Variables Definition in CFX Solver 5.6	R P	CFX	2	October 26, 2004 03:13