|
[Sponsors] |
February 18, 2004, 23:01 |
CATALYST LINE FAILURE
|
#1 |
Guest
Posts: n/a
|
Dear members
I am one of the new user to CFX.my problem is this: Catalyst is a solid it is transfored to process line through air, but leakage happened with in 2 years of operation. Is it possible to find the cause of failure of catalyst line in petrochemical refinary? I know a little bit of theory about CFX? with this can I able to solve it or nor? looking for advise yours suresh.J |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 03:09 |
OpenFOAM 1.7.1 installation problem on OpenSUSE 11.3 | flakid | OpenFOAM Installation | 16 | December 28, 2010 09:48 |
Regarding FoamX running Kindly help out | hariya03 | OpenFOAM Pre-Processing | 0 | April 18, 2008 05:26 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 15:00 |
error while compiling the USER Sub routine | CFD user | CFX | 3 | November 25, 2002 16:16 |