CFX does not find Named Selections

emspinosa · March 10, 2018, 12:14

Hey everyone,

I am running a simulation with ANSYS CFX from ANSYS Workbench. I have a three part solid. I put all the solids in a single Part in Design Modeler, as they told me that this is the best way to have a conformal mesh at the interfaces.

However, in this case ANSYS CFX Pre does not recognize the names of the interface surfaces, which I named all with in an appropriate "Named Selection" to properly setup the interface conditions in the simulation.

How can I solve this problem? This creates me a lot of confusion when I try to set the interface conditions in CFX-Pre

Please let me know. Thanks a lot.
E.

urosgrivc · March 12, 2018, 10:00

CFX automaticly defines these sliced regions vhich are meshed 1 to 1 and conects them. The fluid or heat and other variables will automaticaly flow through this interface.

March 10, 2018, 12:14	CFX does not find Named Selections	#1
emspinosa New Member Emanuele Spinosa Join Date: Oct 2014 Location: Manchester, UK Posts: 26 Rep Power: 12	Hey everyone, I am running a simulation with ANSYS CFX from ANSYS Workbench. I have a three part solid. I put all the solids in a single Part in Design Modeler, as they told me that this is the best way to have a conformal mesh at the interfaces. However, in this case ANSYS CFX Pre does not recognize the names of the interface surfaces, which I named all with in an appropriate "Named Selection" to properly setup the interface conditions in the simulation. How can I solve this problem? This creates me a lot of confusion when I try to set the interface conditions in CFX-Pre Please let me know. Thanks a lot. E.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ANSYS12 - named selections not transferred	enigma	Main CFD Forum	8	July 16, 2024 08:23
[DesignModeler] Named selections - is there a quick way to do it?	Marion	ANSYS Meshing & Geometry	2	May 24, 2013 11:05
[ANSYS Meshing] Missing Named Selections	kschong	ANSYS Meshing & Geometry	3	June 4, 2012 05:04
CFX-Pre problem, pls help!!!	cth_yao	CFX	0	February 17, 2012 01:52
How to Find CD by using Wind Tunnel and CP by using ANSYS CFX	Hutaru	Main CFD Forum	0	February 2, 2012 23:43

March 12, 2018, 10:00		#2
urosgrivc Senior Member urosgrivc Join Date: Dec 2015 Location: Slovenija Posts: 365 Rep Power: 12	CFX automaticly defines these sliced regions vhich are meshed 1 to 1 and conects them. The fluid or heat and other variables will automaticaly flow through this interface.