Tetra and Periodicity

September 23, 2003, 06:58

Hi people,

I'm working with Icem Tetra mesher at the moment. I have a problem with the periodic surfaces, this surfaces are Rotational periodic with 77.14°. The mesh that Tetra makes is usless it does not match with the geometry. But if I have the same model with a periodicity of 77°, than the mesh match with the geometry.

Is possiple with Terta to mesh a geomerty with a Rotational periodicity of not integer angles?

Thanks.

Daniele

September 24, 2003, 08:07

look at this

http://www.cfd-online.com/Forum/main.cgi?read=28205

September 23, 2003, 06:58	Tetra and Periodicity	#1
Daniele Guest Posts: n/a	Hi people, I'm working with Icem Tetra mesher at the moment. I have a problem with the periodic surfaces, this surfaces are Rotational periodic with 77.14°. The mesh that Tetra makes is usless it does not match with the geometry. But if I have the same model with a periodicity of 77°, than the mesh match with the geometry. Is possiple with Terta to mesh a geomerty with a Rotational periodicity of not integer angles? Thanks. Daniele

September 24, 2003, 08:07	Re: Tetra and Periodicity	#2
Helge Guest Posts: n/a	look at this http://www.cfd-online.com/Forum/main.cgi?read=28205

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] ansys icem tetra mesh to fluent_v6 conversion problems	milleniumrider	ANSYS Meshing & Geometry	5	May 20, 2010 16:55
[Commercial meshers] ansys icem tetra mesh to fluent_v6 conversion problems	milleniumrider	OpenFOAM Meshing & Mesh Conversion	3	May 13, 2010 15:54
ICEM: unstruct tet grid with periodicity?	Markus	CFX	5	October 2, 2008 08:14
Rotational periodicity on tetra meshes with ICEM	jorllam	CFX	0	February 2, 2006 16:39
ICEM tetra	Ben	CFX	1	November 12, 2003 19:24