tascflow - impeller volute interface -- CFD Online Discussion Forums

August 21, 2003, 14:06	tascflow - impeller volute interface	#1
abaqus Guest Posts: n/a	I am planning to simulate impeller volute together in Tascflow. Frozen rotor interface applied between impeller outlet and volute inlet. But there should not be any solid surface at interface. In my model vane thickness is coming at the interface. How to deal with it. Can I simulate impeller and volute separately. In this case impeller can be solved by simulating one passage between the vanes. And after impleller solution how to put it around volute inlet. Send suggestions....

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wind turbine simulation	Saturn	CFX	60	July 17, 2024 06:45
Volute outlet flow into impeller inlet	Anthony_impeller	CFX	4	December 13, 2011 17:17
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 05:05
Convective Heat Transfer - Heat Exchanger	Mark	CFX	6	November 15, 2004 16:55
Replace periodic by inlet-outlet pair	lego	CFX	3	November 5, 2002 21:09

All times are GMT -4. The time now is 23:41.