How to composite this two surface together???

July 22, 2003, 05:35

Hello everyone. I am now tring to build an airway geometry of human's lung. But there are something wrong with it. I have post it in the following address. Please help me to have a look at it. http://202.113.227.137/private/adang/airway/flange.html Thank you very much.

July 22, 2003, 21:08

Hi Adang,

It looks like you have created the surface just fine. You still have to close off the ends, however, in order to generate a B-Rep solid. To do so, combine the curves at each end into a single closed loop using Create>Curve>Chain. You can then create planar trimmed surfaces using each loop as the "outer loop" in the Create>Surface>Trimmed form.

Regards, Robin

July 22, 2003, 22:03

Hi, Robin

Thank you very much. With your great help I have got it.

Sincerely Adang

July 22, 2003, 05:35	How to composite this two surface together???	#1
adang Guest Posts: n/a	Hello everyone. I am now tring to build an airway geometry of human's lung. But there are something wrong with it. I have post it in the following address. Please help me to have a look at it. http://202.113.227.137/private/adang/airway/flange.html Thank you very much.

July 22, 2003, 21:08	Re: How to composite this two surface together???	#2
Robin Guest Posts: n/a	Hi Adang, It looks like you have created the surface just fine. You still have to close off the ends, however, in order to generate a B-Rep solid. To do so, combine the curves at each end into a single closed loop using Create>Curve>Chain. You can then create planar trimmed surfaces using each loop as the "outer loop" in the Create>Surface>Trimmed form. Regards, Robin

July 22, 2003, 22:03	Re: How to composite this two surface together???	#3
Adang Guest Posts: n/a	Hi, Robin Thank you very much. With your great help I have got it. Sincerely Adang

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Problems with coedge curves and surfaces	tommymoose	ANSYS Meshing & Geometry	6	December 1, 2020 12:12
[Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible	velan	OpenFOAM Meshing & Mesh Conversion	3	October 22, 2015 12:05
[Gmsh] Problem with Gmsh	nishant_hull	OpenFOAM Meshing & Mesh Conversion	23	August 5, 2015 03:09
[Gmsh] boundaries with gmshToFoam‏	ouafa	OpenFOAM Meshing & Mesh Conversion	7	May 21, 2010 13:43
CFX4.3 -build analysis form	Chie Min	CFX	5	July 13, 2001 00:19