Hi All, Have any one of you come across an interpolation error in cfx5.6, when you try to interpolate a 5.6 coarse mesh result file onto a 5.6 fine mesh def file. Pl. note the error is for a case with 3 domains and if I'm right 5.6 does a domain comparison which was not present in 5.5.1, could this be an issue?

eager for your reply

Danie

Danie,

You are right that 5.5.1 did not do a domain comparison, but it used to fail because of this. CFX-5.6 does check what domain it is in, however this is not likely to be the source of your error. I suggest sending your case to customer support for further assistance.

Regards, Robin