 |
 |
 |
|
|
|
[Sponsors] | ||||
July 15, 2003, 17:57
|
GGI Error Message
|
#1 |
|
Guest
Posts: n/a
|
Hello everyone,
I use CFX-Pre 5.6 to build a model in which five Patran Neutral blocks were imported. Domain Interfaces (no Frame change, no Pitch change) were assigned in the model. When I tried to solver the problem, I got the following error message in CFX 5.6 Solver. Anybody knows the reason and what should I do to revise the model? Thanks in advance! David ERROR #001100279 has occurred in subroutine ErrAction. | Message: | No control surfaces have been found at all for case and drill com- | . This is not supported. | ERROR #001100279 has occurred in subroutine ErrAction. Message: Stopped in routine SU_MESH_GGI |
|
|
||
|
July 16, 2003, 02:01
|
Re: GGI Error Message
|
#2 |
|
Guest
Posts: n/a
|
David,
One of your GGI interfaces is not overlapping. Carefully check that side 1 and side 2 are overlapping. You can do this in CFX-Pre or Post. Neale |
|
|
|
||
|
July 16, 2003, 13:47
|
Thank you, Neale
|
#3 |
|
Guest
Posts: n/a
|
Thank you Neale! You are right.
Regards David |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ggi | FabOr | OpenFOAM | 17 | May 9, 2013 11:19 |
| GGI Tolerance | taner | OpenFOAM Running, Solving & CFD | 18 | February 12, 2013 16:58 |
| Difference between ggi and overlapGgi? GGI Tips and Tricks? | philippose | OpenFOAM Running, Solving & CFD | 7 | January 16, 2013 10:40 |
| GGI in OpenFOAM-1.5-dev | philippose | OpenFOAM Running, Solving & CFD | 14 | November 13, 2011 15:55 |
| Problem using GGI | besto | OpenFOAM | 13 | October 30, 2010 08:34 |
Linear Mode
