|
[Sponsors] |
July 5, 2003, 13:07 |
create screw in CFX built
|
#1 |
Guest
Posts: n/a
|
Hello all,
I have a problem in creating a screw in CFX5.5.1, In order to generate giometric solid as a screw shape, I created a screw surface from many curve and when i have a close surface, then I created a solid by using b-rep. But the program report that there are a gap between a surface and no solid created. Could any body give me some idea how can I fix this problem please. Thank you very much for all kind answer, Methee. |
|
July 8, 2003, 23:28 |
Re: create screw in CFX built
|
#2 |
Guest
Posts: n/a
|
try to change the tolerance when you set up the problem...for example change from 0.05 to 0.1..
Good luck |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Actuator disk model | audrich | FLUENT | 0 | September 21, 2009 08:06 |
Where's the singularity/mesh flaw? | audrich | FLUENT | 3 | August 4, 2009 02:07 |
Error: create mesh in CFX | Ac-Joker | CFX | 2 | June 11, 2009 07:52 |
Importing solutions in CFX. | Alphonso | CFX | 1 | August 1, 2008 15:01 |
CFX 4.4 installation problem | Pandu Sattvika | CFX | 1 | December 1, 2001 05:07 |