|
[Sponsors] |
June 30, 2003, 05:42 |
data array too small
|
#1 |
Guest
Posts: n/a
|
I am currently trying to run a problem, however I get a ERROR #001100279 has occured in subroutine ErrAction. Message: RedSht: size of data array is too small: what=G/IPESVL where=ZN1
I am using cfx 5.5.1, I have tried increasing the stack memory but this didn't help. Can anyone suggest anything else for me to try. Thank you, blair |
|
June 30, 2003, 13:59 |
Re: data array too small
|
#2 |
Guest
Posts: n/a
|
Is the size of a fluid sub-domain as a volumetric momentum source likely to cause this error? I had a larger fluid sub-domain before and it worked, is there a minimum number of cells in a sub domain?
|
|
July 2, 2003, 02:01 |
Re: data array too small
|
#3 |
Guest
Posts: n/a
|
There should not be. The message is a bit cryptic, but it is a problem with the mesh and topology generated by CFX-5-Build. Send your database to a support rep to have a look at it.
Neale |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem in running ICEM grid in Openfoam | Tarak | OpenFOAM | 6 | September 9, 2011 18:51 |
CGNS vs Tecplot Data Format | LWhitson2 | Main CFD Forum | 3 | July 1, 2011 14:50 |
Saving particle (DPM) data to file? | Philip | FLUENT | 2 | June 12, 2006 02:41 |
Postprocessing Pressure data spanwise over a wing | Rick | FLUENT | 1 | February 3, 2006 10:28 |
tracking data with respect to time | tucker | FLUENT | 2 | December 20, 2005 09:39 |