Animation

June 12, 2003, 12:04

Has somebody tried to animate any results in the post processor?, Does any tutorial make reference about this?.

Take Care

Carola

June 12, 2003, 13:43

Hi Carola,

There are several tutorials which use animation. At the start of the tutorials section in the manual, under the list of features link there is a table which lists features down the left hand side and tutorial numbers across the top. From this table, you can easily find a tutorial which uses the feature you are interested in.

Regards, Robin

June 12, 2003, 12:04	Animation	#1
Carola Guest Posts: n/a	Has somebody tried to animate any results in the post processor?, Does any tutorial make reference about this?. Take Care Carola

June 12, 2003, 13:43	Re: Animation	#2
Robin Guest Posts: n/a	Hi Carola, There are several tutorials which use animation. At the start of the tutorials section in the manual, under the list of features link there is a table which lists features down the left hand side and tutorial numbers across the top. From this table, you can easily find a tutorial which uses the feature you are interested in. Regards, Robin

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Creating animation through TUI	wawa	FLUENT	27	November 5, 2021 04:17
Cropping animation spatially	smonsch	ANSYS	0	September 3, 2009 15:09
Multiblock animation in Tecplot.	Simon	Tecplot	4	February 10, 2006 11:27
Animation query..newbie qn	derick	FLUENT	2	December 9, 2005 10:45
Animation in Tecplot	ryoga	Tecplot	0	February 18, 2002 12:19