 |
 |
 |
|
|
|
[Sponsors] | ||||
June 3, 2003, 05:46
|
Dual temperature boundary condition
|
#1 |
|
Guest
Posts: n/a
|
I need to specify an atmospheric boundary, where the specified temperature is dependent on the flow direction. For flow into the domain, the specified temperature should be the ambient atmospheric value, but for flow out of the domain I want to specify a zero-gradient condition. I know CEL would probably be the way to do this, but how? The problem basically is how to "detect" whether the flow in into or out of the domain at the boundary, and if out, how do I specify a zero gradient? I'm using CFX 5.5.1
Louwrens |
|
|
||
|
June 3, 2003, 22:58
|
Re: Dual temperature boundary condition
|
#2 |
|
Guest
Posts: n/a
|
Hi Louwrens,
This is what you get when you use an opening. If flow is coming into the domain, the temperature is whatever you specified; if flow is exiting the domain, the temperature is determined by the upstream condition (zero gradient at outlet). Regards, Robin |
|
|
|
||
|
June 4, 2003, 04:58
|
Re: Dual temperature boundary condition
|
#3 |
|
Guest
Posts: n/a
|
Oh the bliss...
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Domain Imbalance | HMR | CFX | 5 | October 10, 2016 06:57 |
| Temperature dependant mixed Boundary condition | argonaut | OpenFOAM Pre-Processing | 2 | February 15, 2011 12:02 |
| How to apply the temperature boundary condition on the outside of the mould? | alefem | FLOW-3D | 5 | May 25, 2010 06:32 |
| Pressure Boundary Condition | Matt Umbel | Main CFD Forum | 0 | January 11, 2002 11:06 |
| boundary condition : temperature | J.D.Yoon | FLUENT | 1 | August 29, 2000 05:08 |
Linear Mode
