 |
 |
 |
|
|
|
[Sponsors] | ||||
Import iges file into CFX5.4.1 in Unix system |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 2, 2003, 03:36
|
Import iges file into CFX5.4.1 in Unix system
|
#1 |
|
Guest
Posts: n/a
|
When I tried to import an iges file produce with Invetor6.0 in WindowXP system into CFX5.4.1 in Unix system, the following information was shown. "The specified file filename.igs is not a valid fixed(80 character) line length ASCII format" Can anyone help me? Bob, thank you for your information.
|
|
|
||
|
May 2, 2003, 09:28
|
Re: Import iges file into CFX5.4.1 in Unix system
|
#2 |
|
Guest
Posts: n/a
|
What is the length of the path (should be less than 80 character)? Can the file be tared and read on Unix, or is the file corrupted after you transfered it?
PS: CFX-5 is now on 5.6 I believe (or about to be delivered); how come you are on 5.4.1? |
|
|
|
||
|
May 5, 2003, 09:49
|
Re: Import iges file into CFX5.4.1 in Unix system
|
#3 |
|
Guest
Posts: n/a
|
Use Hummingbird exceed3d software to transfer files from PC to UNIX platform. It will convert the files in proper format and will solve your problem.
|
|
|
|
||
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [swak4Foam] swak4foam building problem | GGerber | OpenFOAM Community Contributions | 54 | April 24, 2015 17:02 |
| [blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 15:11 |
| [Gmsh] Compiling gmshFoam with OpenFOAM-1.5 | BlGene | OpenFOAM Meshing & Mesh Conversion | 10 | August 6, 2009 05:26 |
| [OpenFOAM] Paraview command not found | hardy | ParaView | 7 | September 18, 2008 05:59 |
| Compiling OpenFOAM13 on AMD64 with Redhat Enterprise | mbeaudoin | OpenFOAM Installation | 20 | June 17, 2008 07:43 |
Linear Mode
