Convergence Criteria Specification

ab12gu · October 30, 2017, 11:33

Does anyone know how to set the convergence criteria to be based on user points?

Also, could I increase the maximum iterations for my run after it ran for the maximum iterations without the system resetting from 0 iterations?

ghorrocks · October 30, 2017, 18:42

What do you mean by "user points"?

You can define custom convergence criteria using the interrupt control settings on the solver control tab.

If you want to run for more iterations you can simply restart the simulation using the previous simulation as initial conditions. If the run is currently proceeding you can use "edit run in progress".

October 30, 2017, 11:33	Convergence Criteria Specification	#1
ab12gu New Member Abhay Gupta Join Date: Oct 2017 Posts: 1 Rep Power: 0	Does anyone know how to set the convergence criteria to be based on user points? Also, could I increase the maximum iterations for my run after it ran for the maximum iterations without the system resetting from 0 iterations?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ANSYS Mechanical - change convergence criteria	KeganLeckness	Structural Mechanics	2	May 12, 2022 06:57
question about convergence criteria in Flow Simulation	drdet	FloEFD, FloWorks & FloTHERM	2	January 16, 2015 10:36
Force can not converge	colopolo	CFX	13	October 4, 2011 23:03
What value shall I set for the Convergence criteria?	steventay	CFX	7	May 14, 2010 13:44
Convergence Criteria	edwin	FLUENT	1	February 14, 2008 20:24

October 30, 2017, 18:42		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,870 Rep Power: 144	What do you mean by "user points"? You can define custom convergence criteria using the interrupt control settings on the solver control tab. If you want to run for more iterations you can simply restart the simulation using the previous simulation as initial conditions. If the run is currently proceeding you can use "edit run in progress".