|
[Sponsors] |
January 27, 2003, 09:11 |
2D Regions and Post-processing
|
#1 |
Guest
Posts: n/a
|
Hi everybody! I have this problem, if somebody can help.... I want to create a plot on a individual and internal surface of my domain during post-processing. For this, after I created the 3D region with the geometry, I created the 2D regions with the enter and outlet surfaces of the domain to allow boundary conditions, then I created an additional 2D region with the internal surface where i want to plot results but in the post-processing this region disappears, I can see the 2 regions where I set the boundary conditions, but the other region is not in the domain.
Thanks!!! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
isolated fluid regions were found | alfin | CFX | 14 | October 8, 2015 01:36 |
How to plot Isolated Volume in Post | Jeniffer | CFX | 6 | August 31, 2015 18:12 |
Geometry preparation and post pro | lovecraft22 | OpenFOAM | 4 | June 29, 2011 03:29 |
Plotting recirculation zone in CFD Post | ashtonJ | CFX | 0 | April 30, 2011 20:31 |
post processing unsteady species transport | solomon | FLUENT | 0 | October 25, 2003 17:44 |