Mesh adaption

January 19, 2003, 17:41

Hi all,

1) Does anyone know how to change the mesh adaption parameters outside Build?

2) I have imported a hex mesh and a tet-prism-mesh into CFX Build 5.5.1. I have connected them with a GGI. Now mesh adaption seems not available anymore. Does anyone know a workaround?

Astrid

January 20, 2003, 15:13

Hi Astrid,

1) You will not be able to set adaption parameters in CCL until version 5.6.

2) Mesh adaptation is currently limited to single domain problems (i.e. no adaptation with GGI). If they can be run separately (such as with a rotor - stator combination), you could run each part with adaption then combine the adapted meshes.

Regards, Robin

January 19, 2003, 17:41	Mesh adaption	#1
Astrid Guest Posts: n/a	Hi all, 1) Does anyone know how to change the mesh adaption parameters outside Build? 2) I have imported a hex mesh and a tet-prism-mesh into CFX Build 5.5.1. I have connected them with a GGI. Now mesh adaption seems not available anymore. Does anyone know a workaround? Astrid

January 20, 2003, 15:13	Re: Mesh adaption	#2
Robin Guest Posts: n/a	Hi Astrid, 1) You will not be able to set adaption parameters in CCL until version 5.6. 2) Mesh adaptation is currently limited to single domain problems (i.e. no adaptation with GGI). If they can be run separately (such as with a rotor - stator combination), you could run each part with adaption then combine the adapted meshes. Regards, Robin

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Gambit problems	Althea	FLUENT	22	January 4, 2017 04:19
[ICEM] Negative volume error in hybrid mesh	siw	ANSYS Meshing & Geometry	4	September 3, 2014 06:25
Unstructured Mesh using Mesh adaption	sidzishere	CFX	1	May 31, 2011 11:18
Mesh adaption	anand	FLUENT	0	February 10, 2009 01:07
Convergence moving mesh	lr103476	OpenFOAM Running, Solving & CFD	30	November 19, 2007 15:09