|
[Sponsors] |
December 2, 2002, 08:20 |
meshing
|
#1 |
Guest
Posts: n/a
|
Hello all,
In my previous work, My model is a full of stirred tank. It take a time to run not so long but I think it will be better to model it just a half of symmetry tank if the boundary condition is more complicate.However, when i model it just a half of stirred tank. I have a problem with creating the volume mesh. I can created a surface mesh but when I try to write the definition file it's not successfull. I've got an error message like this ''Edge of current face was not found in search box' Could anybody can tell me what's cause of this problem and how to solve it please. Jack |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing | David-CFD | ANSYS Meshing & Geometry | 1 | April 1, 2011 05:22 |
Best Meshing scheme for Cylinder | Nutrex | Main CFD Forum | 4 | July 29, 2008 11:03 |
Meshing locks workbench window. | andy2o | CFX | 0 | February 1, 2008 05:01 |
Singularity of grid?Volume meshing vs face meshing | Ken | Main CFD Forum | 0 | September 4, 2003 11:09 |
Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 11:08 |