|
[Sponsors] |
November 16, 2002, 01:40 |
Turbulance parameters
|
#1 |
Guest
Posts: n/a
|
hello, I have two questios, can any body please answer it. 1. How to select the inlet turbulance parameters like dissipation length scale & turbulance intensity in a standard Turbulance modal and How to varify after the solution that whatever values we have choosen are correct,
2. In case of external flows, what are the parameters to be checked to say that the solution has converged you answers are most welcome Irfan |
|
November 18, 2002, 03:16 |
Re: Turbulance parameters
|
#2 |
Guest
Posts: n/a
|
see answer below and check also CFX manual and Rodi (1980s) book.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Reverse rate parameters with CHEMKIN imports | Kevin L | FLUENT | 1 | June 27, 2013 05:22 |
twoPhaseEulerFoam - parameters | grjmell | OpenFOAM | 1 | June 16, 2011 09:13 |
units of geometrical parameters lost | SoobY | ANSYS Meshing & Geometry | 2 | January 10, 2011 04:58 |
New to CFX-need explanations about mesh parameters | Cyril | CFX | 3 | November 24, 2006 07:33 |
turbulance model | J.subramani | CFX | 1 | January 4, 2004 18:00 |