|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Dear Friends, I am currently doing some analysis of a geometry with elliptical cross-section. But I am finding it difficult to make one in CFX4.4 Build. If there is an exclusive option available, please let me know. Thanks in advance sudar
|
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
Hi!
Which preporcessor are you using? I am using meshbuilder for CFX-4. It is possible to build an elliptical cross-section. Go to Geometry option and make curve with multiple points (I assume you know the coordinates of the point). Four curves is enough to build a face and extrude this face to become a block. MHW |
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
Hi I know the major and minor axis of the ellipse. For example the dimensions are 30mm and 40mm. How to build it with the help of 4 points only. or I need to find out the other also to do the same. I am using the CFX4.4 Build. Sudar
|
|
![]() |
![]() |
![]() |
#4 |
Guest
Posts: n/a
|
Hi
I have had the same problem in CFX 5.5.1 I asked cfx-support and they said that the fastest is to use the Patran Command Language. You have to get an example of a program and implement the equation of an ellipse. It works fine but it was a lot of work at the beginning. I can send an example if you want. You just have to crearte a databse and then play the session file into the database. Olivier |
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem Importing Geometry ProE to CFX | fatb0y | CFX | 3 | January 14, 2012 19:42 |
[Gmsh] Problem meshing an imported geometry | Alicia | OpenFOAM Meshing & Mesh Conversion | 0 | March 30, 2010 04:53 |
Simulation of Flow through Complex 3D Geometry | EmersonKB | CFX | 5 | July 2, 2009 08:17 |
vitual _ real | deneb | FLUENT | 3 | January 22, 2007 04:31 |
Generation of elliptical geometry | Glenn Price | FLUENT | 4 | February 3, 2000 09:19 |