cfx steady simulation

maheshchamarti · June 20, 2017, 10:04

iam trying to simulate a two domain one statinary and one rotating domian. the stator has 24 blades and rotor has 12 blades. there are two stator blades in the stator mesh and one blade in the rotor mesh. so passages in 360 is autocalculated by cfx as 12. but when i set up the simulation an error pops up in the cfx pre saying value of no of passages in 360 in object/turbo post data/turbo post component:R1,0 , violates its lower bound 1. also my simulation keeps crashing on high mach no values. i have tried to initialize in different ways but it keeps crashing in less than 10 iterations.

-Maxim- · June 22, 2017, 04:51

do all the tutorials for two domains and rotor/stator cases. You will probably find your mistake after that.
If not, post screenshots, your CCL and your OUT file.

June 20, 2017, 10:04	cfx steady simulation	#1
maheshchamarti New Member Mahesh Chamarti Join Date: Feb 2017 Posts: 17 Rep Power: 9	iam trying to simulate a two domain one statinary and one rotating domian. the stator has 24 blades and rotor has 12 blades. there are two stator blades in the stator mesh and one blade in the rotor mesh. so passages in 360 is autocalculated by cfx as 12. but when i set up the simulation an error pops up in the cfx pre saying value of no of passages in 360 in object/turbo post data/turbo post component:R1,0 , violates its lower bound 1. also my simulation keeps crashing on high mach no values. i have tried to initialize in different ways but it keeps crashing in less than 10 iterations.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Transient simulation -> Steady state solution	saisanthoshm88	CFX	13	April 10, 2024 05:43
VAWT simulation verification issue (CFX)	steve20024	Main CFD Forum	0	February 10, 2015 09:15
Steady Simulation of VAWT	steve20024	Main CFD Forum	4	November 27, 2014 06:02
Lift fluctuations in a steady simulation?	k.vimalakanthan	Main CFD Forum	3	October 17, 2011 07:12
2D simulation - ICEM meshing for CFX question	Ben Makhal	CFX	5	April 11, 2007 09:44

June 22, 2017, 04:51		#2
-Maxim- Senior Member Maxim Join Date: Aug 2015 Location: Germany Posts: 413 Rep Power: 13	do all the tutorials for two domains and rotor/stator cases. You will probably find your mistake after that. If not, post screenshots, your CCL and your OUT file.