Convergence when using coal combustion in CFX4

October 30, 2001, 08:45

Hi!

I am using the coal combustion with edddy break up model in CFX4.4. It seems to be hard to drive the iterative errors (especially for the enthalpy) to an acceptable level. Does anyone have any advise concerning convergence in my case?

Thankful for help.

October 31, 2001, 14:33

Hi,

If you have a calculation where you have obtained a reasonable velocity field. Restart from this dumpfile and set the iteration on hydrodynamic equations to zero, in this way only enthalpy and scalars are calculated. This is always a good approach when the energy equation is solved. Jan

October 30, 2001, 08:45	Convergence when using coal combustion in CFX4	#1
Magnus Guest Posts: n/a	Hi! I am using the coal combustion with edddy break up model in CFX4.4. It seems to be hard to drive the iterative errors (especially for the enthalpy) to an acceptable level. Does anyone have any advise concerning convergence in my case? Thankful for help.

October 31, 2001, 14:33	Re: Convergence when using coal combustion in CFX4	#2
Jan Rusaas Guest Posts: n/a	Hi, If you have a calculation where you have obtained a reasonable velocity field. Restart from this dumpfile and set the iteration on hydrodynamic equations to zero, in this way only enthalpy and scalars are calculated. This is always a good approach when the energy equation is solved. Jan

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem on EDC model for coal combustion	lei	FLUENT	4	September 3, 2015 10:39
Force can not converge	colopolo	CFX	13	October 4, 2011 23:03
Turbulent Dispersion for Coal Combustion	gravis	CFX	2	March 24, 2010 00:56
Coal combustion and ash reaction kinetics	sega	Fluent UDF and Scheme Programming	0	January 21, 2010 09:05
convergence for coal combustion	Benjamin	CFX	1	June 30, 2006 07:12