TASCflow,problem with script and parallel mode

Zbynek Hrncir

Hi everyone, I want to launch tascflow3d in parallel mode by way of the script ,but I always receive error massage

-------------------------------------------------------------------------------------- Parallel process summary information:

__________________________________________________ __________________________ Slave number 1 (Process 2)

Could not start: tascflow3d -par -nr 12127936 -ni 2022150 -nd 6482 -nc 73 -nl 31

Execution terminated by routine SPWSLP.

STOP due to error : Slave Process Terminated --------------------------------------------------------------------------------------

The script contains only "tascflow3d -par2" When I use in the script single CPU mode or when I launch tascflow3d in parallel mode from command line everything is ok. Would you please give me some suggestions where may be problem. I use CFX-TASCflow3d 2.10.0-25 and IRIX 6.5