Dear Sir,

When I was creating my Furnace Geometry file using CFX4.3 Build, I found problem to create Advanced Constraint. I have to set-up Advanced Constraint while two edges of my Inlet Patch (Child face) coincides with the two edges of the Parent Face.

Can anyone help me to solve this problem? I have checked the on-line CFX Help, was not very effective for me.

Regards,

Monir Phd Student Swinburne University Melbourne, Australia 23 Jan, 2001

Dear Monir,

-My first advice is 1) Avoid Constrains - use more blocks (KISS) -Second advice 2) Avoid Constrains - use more blocks (KISS)

If you do not want to follow advice 1 or 2 you can get some help on the CFX community page, where there are some course notes on advanced constrains, which are much better than in the help manual.

You can find the pages from www.software.aeat.com/cfx/ log in on the community (you have to get a password from CFX if you dont already have one) goto the Course Notes -> CFX4 Course Notes -> 5. CFX-Build-Constraints

Regards Jan

Dear Monir: I absolutely agree with Jan Rusas. My advice is.... avoid constraints, use more blocks. Best IIN