Stator/Rotor interface of a radial compressor

August 31, 2000, 20:04

I am busy with a simulation of stator-rotor of a radial compressor, but I have a problem with connecting the rotor and stator, because i don't know with which software i must to make the shape of the rotor and stator of this compressor. Anyone know that how do I can to solve this problemt?

Thank you for your help.

Mohamed Shemerti

September 20, 2000, 07:45

Dear Mohamed,

I am sorry if the response is too late for you. Have you tried BladeGen from CFX? I think it can help you to create rotor and stator geometries. By the way, what kind of code are you using for grid generation and simulation? I would be interested to know.

Regards

August 31, 2000, 20:04	Stator/Rotor interface of a radial compressor	#1
mohamed Guest Posts: n/a	I am busy with a simulation of stator-rotor of a radial compressor, but I have a problem with connecting the rotor and stator, because i don't know with which software i must to make the shape of the rotor and stator of this compressor. Anyone know that how do I can to solve this problemt? Thank you for your help. Mohamed Shemerti

September 20, 2000, 07:45	Re: Stator/Rotor interface of a radial compressor	#2
Drona Guest Posts: n/a	Dear Mohamed, I am sorry if the response is too late for you. Have you tried BladeGen from CFX? I think it can help you to create rotor and stator geometries. By the way, what kind of code are you using for grid generation and simulation? I would be interested to know. Regards

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Plotting Radial Velocity and Tangential Velocity in CFD Post	ashtonJ	CFX	5	July 13, 2015 03:49
Centrifugal compressor mass flow error	Attesz	CFX	18	May 27, 2012 11:17
Radial Load calculation	pump_passion	CFX	3	March 31, 2010 18:51
dynamic analysis in diffuser of radial compressor	jeyanth	CFX	2	September 18, 2006 06:44
Echardt compressor	Abdul Nassar	FLUENT	0	November 2, 2005 16:00