No results file created message long after solver start to run

YuguiYo · June 10, 2016, 07:18

Hi all,

I present my issue : The following message " An error has occurred in cfx5solve:The ANSYS CFX solver exited with return code 1. No results file has been created." appeared after exactly 6259 CPU seconds.

I precise that i've done exactly the same simulation, with the same configuration, but with a time step of 0.1s instead of 0.01s. (for a 5s total time). This is the only difference.
My previous run worked perfectly but i just wanted to rise up the number of time step to do a perfect animation from my simulation.

My outfile from the run is very long so i'll not put it here except if someone need it to understand my problem.

Cheers !

Hugo

YuguiYo · June 10, 2016, 10:05

Ok i'm sorry... After looking closely for 1 hour, i've finally understand that my issue was coming from the memory of my computer... Indead the case where my files are saved is full, that's why CFX took so much time to say it to me...

Sry for the silly question !

Bye

June 10, 2016, 07:18	No results file created message long after solver start to run	#1
YuguiYo New Member Hugo Regina Join Date: Apr 2016 Posts: 23 Rep Power: 10	Hi all, I present my issue : The following message " An error has occurred in cfx5solve:The ANSYS CFX solver exited with return code 1. No results file has been created." appeared after exactly 6259 CPU seconds. I precise that i've done exactly the same simulation, with the same configuration, but with a time step of 0.1s instead of 0.01s. (for a 5s total time). This is the only difference. My previous run worked perfectly but i just wanted to rise up the number of time step to do a perfect animation from my simulation. My outfile from the run is very long so i'll not put it here except if someone need it to understand my problem. Cheers ! Hugo

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[OpenFOAM.org] Patches to compile OpenFOAM 2.2 on Mac OS X	gschaider	OpenFOAM Installation	136	October 10, 2017 18:25
[swak4Foam] swak4foam building problem	GGerber	OpenFOAM Community Contributions	54	April 24, 2015 17:02
centOS 5.6 : paraFoam not working	yossi	OpenFOAM Installation	2	October 9, 2013 02:41
[OpenFOAM] Annoying issue of automatic "Rescale to Data Range " with paraFoam/paraview 3.12	keepfit	ParaView	60	September 18, 2013 04:23
Version 15 on Mac OS X	gschaider	OpenFOAM Installation	113	December 2, 2009 11:23

June 10, 2016, 10:05		#2
YuguiYo New Member Hugo Regina Join Date: Apr 2016 Posts: 23 Rep Power: 10	Ok i'm sorry... After looking closely for 1 hour, i've finally understand that my issue was coming from the memory of my computer... Indead the case where my files are saved is full, that's why CFX took so much time to say it to me... Sry for the silly question ! Bye