pressure and initial condition

hossein_sml · March 22, 2016, 13:17

Hi
I am trying to simulate a close container which contains water and also simulating free surface and sloshing

I have faced very strange problem.
Although i have defined initial static pressure of water by ccl. [below image], when i check pressure in CFD-Post (in t=0s) the pressure distribution all over the container is constant and equal to zero.
Also after progressing time the pressure is not changing in all over the cube!

why it is happening? Any suggestion?

Opaque · March 22, 2016, 14:22

You are showing the expression, but not the CCL where it is used.

Are you certain the expression is used in the correct place ? There is domain initialization, and there is global initialization. Which of the two are you using ?

Hope the above helps,

hossein_sml · March 22, 2016, 14:49

I have set it in global setting.
Also i tried to set initial condition in domain initialization.
nothing changed and the result is same.

Opaque · March 22, 2016, 15:08

Can you show your CCL (command language) ?

hossein_sml · March 22, 2016, 15:37

Quote:

Originally Posted by Opaque

Can you show your CCL (command language) ?

The ccl is uploaded

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Maximum number of iterations exceeded chtmultiregionsimpleFoam	Moncef	OpenFOAM Running, Solving & CFD	28	July 13, 2020 15:26
Floating point exception error	lpz_michele	OpenFOAM Running, Solving & CFD	53	October 19, 2015 03:50
Wrong fluctuation of pressure in transient simulation	caitao	OpenFOAM Running, Solving & CFD	2	March 5, 2015 22:33
Micro Scale Pore, icoFoam	gooya_kabir	OpenFOAM Running, Solving & CFD	2	November 2, 2013 14:58
Orifice Plate with a fully developed flow - Problems with convergence	jonmec	OpenFOAM Running, Solving & CFD	3	July 28, 2011 06:24

March 22, 2016, 14:22		#2
Opaque Senior Member Join Date: Jun 2009 Posts: 1,880 Rep Power: 33	You are showing the expression, but not the CCL where it is used. Are you certain the expression is used in the correct place ? There is domain initialization, and there is global initialization. Which of the two are you using ? Hope the above helps,

March 22, 2016, 14:49		#3
hossein_sml New Member hossein Join Date: May 2012 Posts: 28 Rep Power: 14	I have set it in global setting. Also i tried to set initial condition in domain initialization. nothing changed and the result is same.

March 22, 2016, 15:08		#4
Opaque Senior Member Join Date: Jun 2009 Posts: 1,880 Rep Power: 33	Can you show your CCL (command language) ?