error befor stast runing

yaseen wsu · February 17, 2016, 02:21

hello every one
before start any iteration, my running model stop and shows error??
as show in image
http://www.cfd-online.com/Forums/att...1&d=1455690029

ghorrocks · February 17, 2016, 06:41

There is a problem with your CCL. You need to fix that, or if you cannot find it you should load it in CFX-Pre again and check the setup. You have missed something - but the error message gives no clues as to what the missing thing is unfortunately.

yaseen wsu · February 17, 2016, 06:50

dear Glenn Horrocks, I re loaded not one time, more than five time and reduced mesh density increase memory partition but the error msg. repeated this time I will begin from the first point I hope to be run.

ghorrocks · February 17, 2016, 07:11

If you have redone it through CFX-Pre then you need to start from a simple model and add your bits and pieces one at a time and see when it stops working.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Batch Job Runing under Linux Environment	ck5285	FLOW-3D	9	April 28, 2009 21:47
Runing a simulation	shuo	Main CFD Forum	0	February 15, 2008 17:43
runing Fluent with a 64bit machine	Rucy	FLUENT	1	November 17, 2005 09:51
Runing Out of memory in Gambit	Akin	FLUENT	6	February 10, 2005 16:32
runing FLUENT on celeron CPU?	Howell	FLUENT	6	April 2, 2002 05:14

February 17, 2016, 06:41		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,871 Rep Power: 144	There is a problem with your CCL. You need to fix that, or if you cannot find it you should load it in CFX-Pre again and check the setup. You have missed something - but the error message gives no clues as to what the missing thing is unfortunately.

February 17, 2016, 06:50		#3
yaseen wsu Senior Member yaseen Join Date: Oct 2015 Location: Hawler Posts: 174 Rep Power: 11	dear Glenn Horrocks, I re loaded not one time, more than five time and reduced mesh density increase memory partition but the error msg. repeated this time I will begin from the first point I hope to be run.

February 17, 2016, 07:11		#4
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,871 Rep Power: 144	If you have redone it through CFX-Pre then you need to start from a simple model and add your bits and pieces one at a time and see when it stops working.