cfx-pre(solver control)

heydari · July 27, 2015, 16:26

Hi;
please;See Attachments and help me.

Opaque · July 27, 2015, 16:39

If you cannot take the time to describe what you are trying to model, and write down your questions in a legible, and organized manner, it will be very difficult that a soul in the forum spend their valuable time to help you.

heydari · July 27, 2015, 17:27

I'm sorry, I thought this form you understand the question better.
However, my intention is to simulate an open channel where we find these values should be?
(1) for the first picture I've reduced the timescale factor and thus respond faster and finally converged. Is this true? and is 0.5 values to be used?and...
2. The second image: the values specified Where should I get? (Of course, to simulate open channel).

ghorrocks · July 27, 2015, 19:23

I suspect you want a free surface model but you are using particle multiphase. Have a look at the setup for the "free surface flow over a bump" tutorial for how to set up homogeneous free surface models.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
control variable bound in cfx	klarke	CFX	5	June 24, 2014 20:15
An error has occurred in cfx5solve:	HMR	CFX	5	February 21, 2012 04:41
CFX or Fluent for Turbo machinery ?	Far	FLUENT	3	May 27, 2011 04:02
in CFX, how to define a inlet condition of feedback control flow rate ?	suihenry	CFX	12	May 14, 2009 18:59
CFX 4.4 installation problem	Pandu Sattvika	CFX	1	December 1, 2001 05:07

July 27, 2015, 16:39		#2
Opaque Senior Member Join Date: Jun 2009 Posts: 1,880 Rep Power: 33	If you cannot take the time to describe what you are trying to model, and write down your questions in a legible, and organized manner, it will be very difficult that a soul in the forum spend their valuable time to help you.

July 27, 2015, 17:27		#3
heydari Member A.heydari Join Date: May 2015 Location: IRAN Posts: 31 Rep Power: 11	I'm sorry, I thought this form you understand the question better. However, my intention is to simulate an open channel where we find these values should be? (1) for the first picture I've reduced the timescale factor and thus respond faster and finally converged. Is this true? and is 0.5 values to be used?and... 2. The second image: the values specified Where should I get? (Of course, to simulate open channel).

July 27, 2015, 19:23		#4
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,872 Rep Power: 144	I suspect you want a free surface model but you are using particle multiphase. Have a look at the setup for the "free surface flow over a bump" tutorial for how to set up homogeneous free surface models.