|
[Sponsors] |
Solver finished normally without convergence before max. Number of iterations |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 1, 2015, 14:03 |
Solver finished normally without convergence before max. Number of iterations
|
#1 |
New Member
Join Date: Jun 2014
Posts: 1
Rep Power: 0 |
Hello,
I have a question concerning convergency . In my case the solver stops running before reaching the maximum Number of iteration steps, but not all of the variables does converge. The Message box says " run has finished normally" Could any One Tell me whx this Happens and what it means? I searched after an answer in the Forum and the manuals, but I didn't find anything. Thank you very much in advance! Best Regards oddo |
|
January 1, 2015, 23:52 |
|
#2 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,819
Rep Power: 144 |
The output file will tell you why it stopped. Just look back further into the final stages of the output file.
|
|
Tags |
solver finished |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
calculation stops after few time steps | sivakumar | OpenFOAM Running, Solving & CFD | 7 | March 17, 2013 06:37 |
SLTS+rhoPisoFoam: what is rDeltaT??? | nileshjrane | OpenFOAM Running, Solving & CFD | 4 | February 25, 2013 04:13 |
Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3 | bookie56 | OpenFOAM Installation | 8 | August 13, 2011 04:03 |
On the damBreak4phaseFine cases | paean | OpenFOAM Running, Solving & CFD | 0 | November 14, 2008 21:14 |
[blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 07:36 |