Peekca Error

Saleeman1234 · November 4, 2014, 04:28

Hello

I want to insert an expression for thermal contact resistance

TCR= Constant * Temeprature

this temperature is not available on both side
so I get this error

" the Physics setup on domain interface "Plate" contains an expression that refers to a variable that is not available on both sides of the interface. this is not allowed. correct the problem, perhaps by using callback functions that refer to one side only."

Can you please guide me how can I call the function by one side only?
As I know the heat Flow side I can ignore the other side. but I dont know how?

Thanks in Advance

Saleeman1234 · November 4, 2014, 05:39

if I try by making an additional variable I get this error

Error detected by routine PEEKCS
CDANAM = /FLOW/GETVAR/PHYS_ZONE_DIR /SL3 /AV6 /CELAVMAP
CRESLT = NONE

Current Directory : /FLOW/PHYSICS/ZIF3/HEATM/RESIST

+--------------------------------------------------------------------+
| Writing crash recovery file |
+--------------------------------------------------------------------+

+--------------------------------------------------------------------+
| ERROR #001100279 has occurred in subroutine ErrAction. |
| Message: |
| Stopped in routine MEMERR

November 4, 2014, 04:28	Peekca Error	#1
Saleeman1234 Member Mansoor Saleem Join Date: Jun 2014 Posts: 31 Rep Power: 12	Hello I want to insert an expression for thermal contact resistance TCR= Constant * Temeprature this temperature is not available on both side so I get this error " the Physics setup on domain interface "Plate" contains an expression that refers to a variable that is not available on both sides of the interface. this is not allowed. correct the problem, perhaps by using callback functions that refer to one side only." Can you please guide me how can I call the function by one side only? As I know the heat Flow side I can ignore the other side. but I dont know how? Thanks in Advance

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[blockMesh] blockMesh with double grading.	spwater	OpenFOAM Meshing & Mesh Conversion	92	January 12, 2019 10:00
OpenFOAM without MPI	kokizzu	OpenFOAM Installation	4	May 26, 2014 10:17
Errors in UDF	shashank312	Fluent UDF and Scheme Programming	6	May 30, 2013 21:30
OpenFOAM on MinGW crosscompiler hosted on Linux	allenzhao	OpenFOAM Installation	127	January 30, 2009 20:08
Problem with compile the setParabolicInlet	ivanyao	OpenFOAM Running, Solving & CFD	6	September 5, 2008 21:50

November 4, 2014, 05:39		#2
Saleeman1234 Member Mansoor Saleem Join Date: Jun 2014 Posts: 31 Rep Power: 12	if I try by making an additional variable I get this error Error detected by routine PEEKCS CDANAM = /FLOW/GETVAR/PHYS_ZONE_DIR /SL3 /AV6 /CELAVMAP CRESLT = NONE Current Directory : /FLOW/PHYSICS/ZIF3/HEATM/RESIST +--------------------------------------------------------------------+ \| Writing crash recovery file \| +--------------------------------------------------------------------+ +--------------------------------------------------------------------+ \| ERROR #001100279 has occurred in subroutine ErrAction. \| \| Message: \| \| Stopped in routine MEMERR