 |
 |
 |
|
|
|
[Sponsors] | ||||
August 25, 2014, 14:13
|
Problem in porous media flow
|
#1 |
|
New Member
Lissette
Join Date: Aug 2014
Posts: 7
Rep Power: 12  |
Hello
I am trying to get that:  But I am getting this  ..... This is a porous media, I have applied a load to this quarter so that the flow can flow down and up the media. The boundary conditions, I have put are symmetry and wall for the round part and for the up and down direction. I have applied outlets with a static pressure of 0 Kpa, since as long as I apply a load to the up face, the water will flow in two directions up and down... This is a FSI transient problem... Ansys also give me a message that the face with the wall condition should be an opening and there is an overflow... but that is not what I want to get.. Thank you for your attention 
|
|
|
|
|
|
August 25, 2014, 19:44
|
|
#2 |
|
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,872
Rep Power: 144 |
||
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem on boundary conditions (multi-phase, porous media, 3 flow domains) | Juun | FLUENT | 1 | November 19, 2023 02:06 |
| modeling the fluid flow in porous media by Fluent | Mohsen Nazari | FLUENT | 5 | April 26, 2019 05:45 |
| Have problem with 2 phase porous media | Juun | Fluent Multiphase | 2 | October 3, 2013 08:44 |
| flow thru porous media, PLEASE HELP | Goker | FLUENT | 4 | September 8, 2012 05:02 |
| Porous media flow with diffusion | albertinho | OpenFOAM | 0 | March 31, 2010 18:14 |
Linear Mode
