 |
 |
 |
|
|
|
[Sponsors] | ||||
August 20, 2014, 08:28
|
trying to remesh flapping wing
|
#1 |
|
New Member
sayee cs mouli
Join Date: Aug 2014
Posts: 1
Rep Power: 0  |
Im doing remesh for flapping wing..I used displacement as
displacement = (z-0.25[m])*(1-sin(2*pi*3[s^-1]*Time This Run) and as a matter of fact i checked my plot also..sine wave is correct Mesh motion occurred since i gave interrupt control as <10 [deg] However if i want to made for higher frequency mesh deformation will be there so i made replay control, i followed all the steps neatly.. While analyzing re mesh condition comes into image After re meshing at last it is checking monitor point after that step it is showing like Fatal error occurred gCVrdx something.. Message F what is the meaning i made interrupt control as areaAve(Total Centroid Displacement Y)@box |
|
|
|
|
|
March 29, 2015, 06:09
|
|
#2 |
|
New Member
shawn lau
Join Date: Nov 2011
Posts: 1
Rep Power: 0 |
Did u solve this problem? I also met it and it drove me crazy.
|
|
|
|
|
|
 |
| Tags |
| gcrdvx fatal error, remesh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| UDF for Flapping Wing | alijazizaib | Fluent UDF and Scheme Programming | 0 | March 23, 2015 02:43 |
| Dynamic Mesh Errors in Flapping wing analysis | navaneeaero | FLUENT | 0 | December 18, 2014 09:20 |
| CFD of flapping wing mav | sultan | Main CFD Forum | 12 | February 28, 2013 20:01 |
| [Other] Is my setup correct?I am trying to simulate flapping motion of the wing using Dynamic | cfd seeker | ANSYS Meshing & Geometry | 2 | September 13, 2012 07:02 |
| Lift and drag coefficients of a flapping wing aircraft | Julian121 | FLUENT | 36 | August 24, 2012 20:37 |
Linear Mode
