exporting seabed velocities and translate it upwards

powpawell · August 13, 2014, 15:53

Hello,

I run a CFX simulation based on the bathymetry profile (point cloud->surface, 25cm resolution) and I want to export the velocity form the seabed in a table format. Also I want the velocities 1m, 2m etc. above the seabed. Any suggestions, please?

You can see a screenshot here. I still need to change a few inlet boundary conditions, dont worry about that.

thanks very much!!

ghorrocks · August 13, 2014, 19:41

In CFD-Post you could set up a point cloud with all the points you wish to export. Then File>export using the point cloud as a locator.

powpawell · September 2, 2014, 05:48

Yeah, that's it. It's done now. Thanks for that!

August 13, 2014, 15:53	exporting seabed velocities and translate it upwards	#1
powpawell New Member Pavel Join Date: Aug 2014 Posts: 15 Rep Power: 12	Hello, I run a CFX simulation based on the bathymetry profile (point cloud->surface, 25cm resolution) and I want to export the velocity form the seabed in a table format. Also I want the velocities 1m, 2m etc. above the seabed. Any suggestions, please? You can see a screenshot here. I still need to change a few inlet boundary conditions, dont worry about that. thanks very much!!

August 13, 2014, 19:41		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,870 Rep Power: 144	In CFD-Post you could set up a point cloud with all the points you wish to export. Then File>export using the point cloud as a locator.

September 2, 2014, 05:48		#3
powpawell New Member Pavel Join Date: Aug 2014 Posts: 15 Rep Power: 12	Yeah, that's it. It's done now. Thanks for that!