|
[Sponsors] |
June 16, 2014, 23:51 |
Mesh refining using sphere of influence
|
#1 |
New Member
Tom
Join Date: Oct 2013
Location: Auckland, New Zealand
Posts: 24
Rep Power: 12 |
Dear all
I am trying to refine mesh around the estimated transition (LSB) location around the thick aerofoil -S814 for the low Reynolds number flow. I had already created two spheres of influence as shown in the Figure attached, the element size are 0.00425 m and 0.00015 m for the bigger and smaller spheres. On top of these two spheres, I want to add an addition small sphere as shown in Figure with 0.000075 m of element size....However, the CFX has shown nothing changed from the original mesh (the two spheres) with no error messages and a green tick after it finish meshing. The local min size is set below the element size of the sphere..... Could anyone tell me how to solve this problem ? Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |
How to control Minximum mesh space? | hung | FLUENT | 7 | April 18, 2005 09:38 |
How to mesh a delta wing in the middle of a sphere | David | FLUENT | 0 | September 2, 2004 13:19 |