a problem about the interface in CFX

309558927 · March 14, 2014, 01:12

hi, I habe a problem about the interface in cfx,the error messages as follow:
no control
surfaces have been found at all for Domain Interface 2- |
| . To work around this please set the expert parameter "ggi permit |
| no intersection = t" .

Hope someone can solve the problem.

ghorrocks · March 14, 2014, 05:03

The error message says exactly what the problem is. Your interface has no connection so is not an interface. If you are doing a transient simulation and the intention is to open an close an oriface then this is fine and use the expert parameter discussed. If this is not intentional then you will have to inspect your geometry and make the two parts of your interface line up.

309558927 · March 14, 2014, 20:37

thanks,the matter was solved.

March 14, 2014, 01:12	a problem about the interface in CFX	#1
309558927 New Member wujun Join Date: Apr 2012 Posts: 13 Rep Power: 14	hi, I habe a problem about the interface in cfx,the error messages as follow: no control surfaces have been found at all for Domain Interface 2- \| \| . To work around this please set the expert parameter "ggi permit \| \| no intersection = t" . Hope someone can solve the problem.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
convergenceof natural convection prob. in cfx	cpkewat	CFX	15	January 31, 2014 07:29
CFX parallel hp MPI problem	fluidmechanics	CFX	5	June 19, 2013 20:05
Problem Importing Geometry ProE to CFX	fatb0y	CFX	3	January 14, 2012 20:42
CFX Casting problem: Can it be done all in one?	jfasl	CFX	1	September 14, 2010 04:14
CFX GGI Interface Error (non-overlapping)	surge519	CFX	1	August 3, 2009 19:54

March 14, 2014, 05:03		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,871 Rep Power: 144	The error message says exactly what the problem is. Your interface has no connection so is not an interface. If you are doing a transient simulation and the intention is to open an close an oriface then this is fine and use the expert parameter discussed. If this is not intentional then you will have to inspect your geometry and make the two parts of your interface line up.

March 14, 2014, 20:37		#3
309558927 New Member wujun Join Date: Apr 2012 Posts: 13 Rep Power: 14	thanks,the matter was solved.