|
[Sponsors] |
June 14, 2013, 03:44 |
Numerical Model
|
#1 |
New Member
Join Date: Dec 2009
Posts: 2
Rep Power: 0 |
Hello,
I'm going to setup a new CFD simulation where I have both fluid-dynamic and heat exchange and both solid and fluid materials. I'm starting with Steady State analysis. Heat exchange is both for conduction (in the solid and in the fluid) and convection. I'm meshing with ICEM TETRA+PRISM and simulating with CFX. What do you suggest as Solver Control parameters/setup (Turbulence Model, Timescale, etc.)? Thank you very much for your suggestions |
|
June 14, 2013, 07:04 |
|
#2 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,819
Rep Power: 144 |
If the flow is turbulent then use a turbulence model. Check the Reynolds number of your flow for this. The CFX documentation and tutorials show how to set basic simulations up.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Error finding variable "THERMX" | sunilpatil | CFX | 8 | April 26, 2013 07:00 |
how to setup a periodic numerical model | saleh alsubari | Main CFD Forum | 0 | August 22, 2012 04:45 |
Wrong calculation of nut in the kOmegaSST turbulence model | FelixL | OpenFOAM Bugs | 27 | March 27, 2012 09:02 |
Problems bout CFD model of biomass gasification, Downdraft gasifier | wanglong | FLUENT | 2 | November 25, 2009 23:27 |