Splining turbine for periodic boundary condition

rameezib · June 11, 2013, 08:01

Dear friends,
I wanted to know how to spline the turbine for using periodic boundary condition, i have a rotor with 30 blades, so i know the angle will be 12 degrees, but how to get the curves on the surfaces to be splined, if my suction and pressure side curves are different ?

ghorrocks · June 11, 2013, 09:18

Turbogrid and bladegen where developed to make exactly this sort of thing easy. Are you using them? Or are you doing it in something else?

rameezib · June 12, 2013, 01:04

Bladegen has provision for only 6 types of turbomachine component, mine is an Impulse turbine, so I'm not able to use Bladegen

ghorrocks · June 12, 2013, 07:09

Try the geometry and meshing forum. Alternately try the forum for whatever solid modelling package you are using.

rameezib · June 13, 2013, 12:06

Hey thanks i have started using bladegen and its really usefull

June 11, 2013, 08:01	Splining turbine for periodic boundary condition	#1
rameezib New Member Rameez Join Date: May 2013 Posts: 19 Rep Power: 13	Dear friends, I wanted to know how to spline the turbine for using periodic boundary condition, i have a rotor with 30 blades, so i know the angle will be 12 degrees, but how to get the curves on the surfaces to be splined, if my suction and pressure side curves are different ?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Radiation interface	hinca	CFX	15	January 26, 2014 18:11
An error has occurred in cfx5solve:	volo87	CFX	5	June 14, 2013 18:44
External Radiation Boundary Condition (Two sided wall), Grid Interface	CFD XUE	FLUENT	0	July 8, 2010 07:49
Rotating interpolated boundary condition	hani	OpenFOAM Running, Solving & CFD	0	July 4, 2006 08:09
The Boundary Condition about the Flat Plate	boing	Main CFD Forum	1	January 6, 2002 17:53

June 11, 2013, 09:18		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,871 Rep Power: 144	Turbogrid and bladegen where developed to make exactly this sort of thing easy. Are you using them? Or are you doing it in something else?

June 12, 2013, 01:04		#3
rameezib New Member Rameez Join Date: May 2013 Posts: 19 Rep Power: 13	Bladegen has provision for only 6 types of turbomachine component, mine is an Impulse turbine, so I'm not able to use Bladegen

June 12, 2013, 07:09		#4
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,871 Rep Power: 144	Try the geometry and meshing forum. Alternately try the forum for whatever solid modelling package you are using.

June 13, 2013, 12:06		#5
rameezib New Member Rameez Join Date: May 2013 Posts: 19 Rep Power: 13	Hey thanks i have started using bladegen and its really usefull