 |
 |
 |
|
|
|
[Sponsors] | ||||
June 3, 2013, 09:09
|
varying quality
|
#1 |
|
New Member
sneha
Join Date: Jun 2013
Posts: 1
Rep Power: 0  |
hi. i am working on numerical simulation of air-water mixture in microchannel heat exchanger i have varied mass flux from 50 to 300 in order to study its effect on pressure drop and void fraction in heat exchanger.please tell me in which options to go if i want to vary quality of mixture along with mass flux. i am using ansys 12.1 and cfx as solver
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] The pre-mesh quality is very good but the mesh quality is bad | lnk | ANSYS Meshing & Geometry | 5 | July 30, 2012 15:11 |
| Improve Mesh quality - airfoil simulation | Lukas84 | STAR-CCM+ | 4 | July 6, 2010 11:07 |
| [ICEM] Hex refinement negative quality afterwards | Anorky | ANSYS Meshing & Geometry | 8 | March 22, 2010 04:25 |
| Different types of Mesh quality | hagupta | CFX | 1 | June 30, 2006 08:42 |
| Gambit Mesh quality | TOM | FLUENT | 1 | February 8, 2002 08:00 |
Linear Mode
